our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

We upgrade our design to use 8 Giga Bytes of DDR4 using 2 Micron chip MT40A4G8NEA-062E:F. I used the SDK 09.02 and sysconfig tools online. Our DDR4 chip are wired with 1 chip select. 1 - Do I need to ...

Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...

The following problems occur in the BQ34Z100 demo test. 1. During the discharge process at 0℃ 1C, the SoC jumps directly from 100% to 0%, and the capacity almost becomes 0. The parameters are as ...

Page 4 of SLUUD32 says "Find the latest firmware in the appropriate BQ41Z50 folder on www.ti.com". Where can the actual *.bq.fs file be found (need the file, or a better link than just www.ti.com).

The open-loop gain in the simulation result (59.9V/mV) is smaller than the minimum value (70V/mV) in the datasheet. Does this mean that the gain in the SPICE model is smaller than the gain in the ...

Reg63 ”DAC Channel Volume Control's Soft-Step control”...Soft-Stepping is 1 step per 1 or 2 DAC Word Clock I would like to check whether there is any pop noise when switching from maximum volume to ...

I have some questions about the manual. 1.Which register does this reset refer to?FRAME_CNT_THRESHOLD(46H) or FRAME_CNTx(45H)? 2.Is the error counter mentioned in the ...

Order of millivolts output swing to be fed into an ADC I'm using currently using TINA-TI to simulate the TIA, with the ultimate goal of producing a tangible physical version of the circuit in the ...

We are using TCAN1145-Q1 to judge it is wake up frame from the network or not by CANINT register bit. While we found when there are other nodes receiving WUF, this TCAN1145 node cannot assert register ...

I am currently working on a project that involves the AM62X platform, and I am encountering an issue when trying to configure GPIO interrupts. I would greatly appreciate your guidance in understanding ...

I'm using the ADC128S102 EVM and I did some measurements I want to save to a log file. I the GUI there is such option but I cant find the location the Log file is generated to. Please help here.